Clean the inner and outer surfaces of your spa using a mild detergent, warm water and a soft brush or cloth. Thoroughly rinse the detergent from the spa before you refill it. Never use cleaners that contain harsh abrasives or rubbing and buffing compounds. They may permanently damage your spa surfaces. Refill the spa according to the instructions located in the «Installation and quick start up guide» of the user’s manual.

No, just plug into the wall to connect to 120 volts, the GFCI is included in the wire and requires only 15 amps. However to connect to 240 volts, you will need a 40 amp breaker.

Yes, our spas are easily portable. They can be transported with a small trailer or simply deposited in the box of a pick-up truck. Our spa models weigh between 300 and 340 lbs. They are easily moved between the house and the cottage.

Yes, our spas are isolated and usable during all 4 seasons (12 months per year) whether you are connecting to 120 volts or 240 volts.

Our spas are convertible “Plug & Play” models. It can simply be plugged into a dedicated 15 amp wall outlet, or it can be converted to 240 volts for better heating efficiency in cold weather. When converting to 240 volts, an electrician will be needed.

Your spa automatically checks the water temperature for one (1) minute, every thirty (30) minutes, to increase the temperature if it has dropped. If you are operating your spa on a 120V electrical supply, the heater will disengage when your pump is turned to high speed. If your set temperature has dropped during usage, the heater may not come on automatically when you change your pump from high speed to low speed. To turn the heater back on, decrease your set temperature by one (1) degree below the current temperature and wait for the display to stop flashing. After stopping, raise the set temperature back to your original setting. This should reengage the heater within one (1) minute.

Our spas are equipped with the Innovaflow Eco-Energy Saver system, which means your heater will be much less solicited and will allow you to save money on electricity consumption. And saving money is always good!

You should drain and refill your spa every one (1) to three (3) months depending on usage. You should also replace the filter cartridge and wipe down the spa as needed. It’s important to have a replacement filter cartridge on hand.

Bromine, lithium or biguanide are recommended. The use of chlorine may result in the cancellation of your warranty.

The maximum temperature is 104 degrees, like all spas in the industry.

InnovaSpa (Lumi-O | Innovaplas inc) continues to provide service for your spa even after your warranty has expired. You can contact InnovaSpa (Lumi-O | Innovaplas inc) at 1-800-363-2396, extension 226, or by email at spaservice@innovaspa.com.

no, our warranty does not cover commercial use, nor does it cover damage that is the result of abnormal use.